Live stream a birthday party so the whole family can join in

To live stream a birthday party, point a phone or laptop at the cake, send it to your own video channel, and text the family one link they can open in any browser. By the end of this guide you will have that link, sound that cuts through a room full of excited kids, and a recording of the candles to keep long after the party is over.

By the Stream Brothers team

Every step was checked against the software's official documentation by independent reviewers before publishing. Last reviewed .

Before you start

Running order
  1. What you need before the party
  2. Which plan fits a family party?
  3. Set up the stream, one step at a time
  4. How do I get good sound in a noisy room?
  5. Keep a recording of the candles
  6. Share the link only with family
  7. Your on-the-day checklist
  8. When a live stream is not the right tool
  9. Your questions

What you need before the party

You need one device that films, one program that sends the picture out, a steady internet connection and somewhere for the video to go. Most families already own everything except the last item.

ItemWhat it doesTip
Phone or laptop with a cameraFilms the partyPlug it into a charger; a long stream drains a battery fast
Larix Broadcaster (phone) or OBS Studio (laptop)The encoder: it packs the picture and sound and sends them outGet them from their makers' official sites or app stores
Wi-Fi or a network cableCarries the stream to the internetTest from the exact spot where the cake will be
A video channelReceives your stream and hands every relative a playerStart on the Free plan to test; it has a one-time setup fee
A small stand or tripodKeeps the shot stillStack books if you have nothing else

An encoder is simply the app that turns your camera into a live signal. It talks to your channel using RTMP, a common way of sending live video that almost every streaming app speaks.

Which plan fits a family party?

Start on the Free plan to test your setup: it gives you one channel for up to 10 viewers at a time, an HLS link and a player without ads, and Stream Brothers describes it as the plan for testing your encoder and player. HLS is the format the player uses, and it plays on phones, tablets, computers and smart TVs without anyone installing anything.

If more than 10 households plan to tune in together, consider Pro on the live video plans page. It takes up to 1,000 viewers at once at 1080p, adds a 50 GB video library for keeping the party video, and starts with 14 days free, then it is billed unless you cancel. Set a reminder to cancel if the party is all you need it for.

Before you rely on any setup, make sure your connection can carry it. Our guide to upload speed for live streaming shows how to measure it in the room you will actually use.

Set up the stream, one step at a time

Do this the day before, not ten minutes before the guests arrive. Pick the laptop route or the phone route.

  1. Create your video channel and open its dashboard. Find the encoder settings (the server address and stream name) and your player link there.
  2. Laptop: install OBS Studio and paste your server address and stream name into its stream settings, as the help pages describe.
  3. Phone: install Larix Broadcaster, add a new connection, and paste the full address of your channel into the Connection URL field. Larix wants the server and the stream name joined into one line, in the shape rtmp://server/app/stream.
  4. Press Start Streaming in OBS, or the start button in Larix.
  5. Open your player link on a second device. You should see yourself waving after a short pause.
  6. Walk around the room while a friend watches the link, so you know the Wi-Fi holds where the cake will be.

The picture reaches viewers a little behind real life. That is normal for this kind of stream, so don't worry if Grandma claps a moment after everyone else.

How do I get good sound in a noisy room?

Move the microphone close to the person who matters, because no software filter can rescue a voice drowned by twenty children. A party is loud, and the people far away mostly want to hear two things: the singing and the birthday child's thank-you.

  • Place the phone or an external microphone a short arm's length from where the cake will sit, not on a shelf across the room.
  • Turn off any music speaker near the microphone during the candles, or the song from the speaker will fight the singing.
  • In OBS, add the Noise Suppression filter to your microphone. OBS explains that it works best on steady background noise such as a fan hum and is generally not effective in loud rooms, so treat it as polish, not a fix.
  • Watch the OBS audio mixer: voices should reach the low end of the red area, and peaking deep in the red means the sound is close to clipping, a harsh crackle viewers will hear.
  • If the sound is too loud, turn it down at the microphone or the device first, then fine-tune the OBS slider.

A quick trick: do a short test recording with the family talking normally, listen back on headphones, and adjust before the real party. OBS itself recommends a test run of a few minutes before your first real stream.

Keep a recording of the candles

Record on your own device while you stream, because live broadcasts are not saved into your channel's library automatically. OBS can record at the same time as it streams, which is the easiest way to end the day with a file.

  1. In OBS, open Settings, then the Output tab, and set Recording Format to MKV. OBS recommends MKV because the file stays usable if the laptop crashes or the recording is not stopped properly.
  2. When the party starts, press Start Streaming and then Start Recording.
  3. Afterwards, turn the MKV into an MP4 that every phone plays: File, then Remux Recordings, choose the file with the ... button, and press Remux. You should see a message when it is done.
  4. If you prefer it automatic, the Advanced settings tab has a box called Automatically remux to mp4.

On Pro or Platinum you can then upload the finished video to your channel's library and add it to the channel's playlist, so the TV station plays it again between live broadcasts.

Share the link only with family

Send the player link in your family group chat or by private message, and never post it on a public page. Anyone who has the link can open the player, so treat it like a house key.

  • Send the link the evening before with the start time in the viewers' own time zone, so nobody joins an hour late.
  • Tell other parents that you are streaming, and point the camera away from children whose families would rather not be shown.
  • If you want a family page with photos and the player on it, the player embeds into any website with one line of code, and web hosting gives you a place for that page.

Your on-the-day checklist

  1. Charger plugged in, camera on its stand, lens wiped.
  2. Microphone near the cake, music speaker switched off for the candles.
  3. Start the stream about ten minutes early so relatives can find it and say hello.
  4. Start the recording.
  5. Keep the player open on a second phone with the sound muted, as a quiet check that it is still live.
  6. Stop the recording before you stop the stream, so the last moments are saved.

When a live stream is not the right tool

A stream like this goes one way: the family watches, but they cannot talk back in real time. If Grandpa wants to sing along on screen and be seen by the birthday child, a video call on a tablet next to the cake does that better, and you can run both.

It is also more than you need if only one or two people are watching; a video call alone may do. And if the picture stutters, our guide to OBS dropped frames helps you find out whether the cause is the laptop or the connection.

Bring the far-away family to the party

Open a channel, test it the day before, and send one link that works on every screen.

Your questions

Do grandparents need to install anything to watch?

No. The player runs in any modern browser on a phone, tablet, computer or smart TV. They tap the link you send and the video starts, with no ads in front of it.

Can I stream the whole party from just my phone?

Yes. Install Larix Broadcaster, paste your channel's full address into the Connection URL field and press the start button. Keep the phone on a charger and on a stand, and remember to save a recording another way, because a live show is not stored on the channel by itself.

How many relatives can watch at the same time?

The Free plan, meant for testing your encoder and player, allows up to 10 viewers at a time. Pro and Platinum take up to 1,000 at once, and both start with 14 days free before billing begins unless you cancel.

Will the stream be saved so people can watch later?

Not automatically: live broadcasts are not recorded into the channel's library. Press Start Recording in OBS while you stream, and if you are on Pro or Platinum, upload that file to your library afterwards, and the channel's TV station can play it between live broadcasts.

What if something stops working in the middle of the party?

Keep a second phone open on the player so you notice straight away, then stop and restart the stream from your encoder. If it still will not connect, open a ticket from our help desk describing what you saw.