How to live stream a concert that sounds as good as the room

To live stream a concert you take a dedicated mix from the sound desk into a computer, add one or two cameras in OBS Studio, send the result over RTMP to a streaming channel, and give fans the channel's link. By the end of this guide you will know what to plug where, which encoder numbers to type in, which songs you are allowed to stream, and how to run a test the day before so the night itself is calm.

By the Stream Brothers team

Every step was checked against the software's official documentation by independent reviewers before publishing. Last reviewed .

Before you start

Running order
  1. The kit, from stage to screen
  2. Getting good sound out of the desk
  3. Where to put the cameras
  4. Encoder settings that fit the channel
  5. Am I allowed to stream these songs?
  6. Going live on your own channel
  7. When this setup is not enough
  8. Your questions

The kit, from stage to screen

A concert stream is a small chain, and each link has one job.

PieceIts jobWhat to look for
A line out of the mixing deskCarries the band's soundA spare aux, matrix or USB output the engineer can feed a stream mix to
An audio interfaceTurns that line into sound the computer hearsLine-level inputs; stereo if the desk can send left and right
One or two camerasThe pictureA clean HDMI output, or a webcam for a small room
A capture cardBrings an HDMI camera into the computerWorks with OBS as a video capture device
A laptop with OBS StudioMixes picture and sound, and encodes the streamFree software; run its Auto-Configuration Wizard first
A wired internet lineSends the stream outA cable to the venue router, not Wi-Fi
A streaming channelTurns your one upload into a link everyone can openRTMP in, a browser player out

Check the upload speed at the venue itself, on the cable you will use, a week before the show. Our guide to upload speed for live streaming walks through measuring it and what to turn down when it falls short.

Getting good sound out of the desk

The best sound comes from a mix made for the stream, sent from the mixing desk on its own output, not from the main speakers' feed. The front-of-house mix is built for the room: the drums and guitar amps are already loud on stage, so the engineer turns them down in the speakers. Copy that mix to the stream and viewers hear a band with no drums. Ask the sound engineer for an aux or matrix send with every instrument and vocal balanced as if nobody were in the room.

Add one or two microphones pointed at the audience, mixed in low. A concert with no clapping between songs feels like a rehearsal; a little room sound makes it feel live.

  1. Plug the desk's stream output into the audio interface, and the interface into the laptop by USB.
  2. In OBS, add an Audio Input Capture source and choose the interface. The meter in the Audio Mixer should move when the band plays.
  3. If the same interface is also picked under Settings, Audio, switch it off there. OBS warns that one device used in both places causes an echo.
  4. Watch the meter during the loudest song. OBS describes its red zone as close to clipping (the harsh crackle when sound is too loud), so keep the band's peaks out of it.
  5. Right-click the source, choose Filters, and add a Limiter. OBS lists it as the filter that prevents distortion, a safety net for the drummer's big finish.
  6. Record a few minutes during soundcheck with Start Recording and listen back on headphones. OBS recommends exactly this before going live.

If the band's lips and the music drift apart, open Advanced Audio Properties in OBS and adjust Sync Offset for the desk source. Clap once on stage in view of the camera and move the value until the clap you hear lines up with the hands you see.

Where to put the cameras

One camera that never moves is worth more than three that wander. Put the first camera at the back or side of the room, framing the whole stage, and lock it off on a tripod. This is your safe shot: whatever happens, you can always cut back to it.

A second camera nearer the stage can follow the singer or a soloist. In OBS, make one scene per camera, each with a Video Capture Device source, and switch between them in the Scenes dock. If a camera shows a black box, the OBS documentation suggests setting its Resolution/FPS Type to Custom and choosing a mode the camera supports.

Coloured stage lights and strobes fool automatic exposure, so set exposure by hand during soundcheck, under the show's real lighting.

Encoder settings that fit the channel

Bitrate is how much data per second the stream uses, and it is the setting to get right first. Your channel on the paid plans takes up to 5 Mbps at 1080p, so the video and audio together have to fit inside that.

Setting in OBSValueWhy
EncoderH.264A codec every player and phone understands
Keyframe Interval2 sYouTube recommends 2 seconds and never more than 4
Audio Bitrate128 kbps, AACYouTube's figure for stereo sound
Sample Rate44.1 kHzYouTube's figure for stereo
Resolution1280x720 or 1920x1080720p leaves room on a slower line
Video BitrateVideo plus audio at or under 5 MbpsThe ingest limit of the channel

Which resolution? For H.264, YouTube lists 720p at a minimum of 3 Mbps (8 Mbps recommended) and 1080p at 30 frames per second at a minimum of 5 Mbps (14 Mbps recommended). Under a 5 Mbps cap that also carries the audio, 720p clears its minimum with room to spare, while 1080p video falls just short of YouTube's figure, so choose 720p unless the venue's line is clearly faster and steadier than that. If frames start dropping, our guide to OBS dropped frames shows how to find the cause.

Am I allowed to stream these songs?

If the band wrote every song and owns the recordings, yes: the rights are yours. Covers are different. Under US copyright law the owner of a song controls public performance, and sending a performance to the public by transmission counts as performing it publicly, whether people watch in one place or in their own homes.

  • Covers: songwriters usually license public performance through performing rights organisations such as ASCAP and BMI. A venue's licence for its live room may not cover an online stream, so ask the venue and the organisation before the show, not after.
  • Recorded music between sets: a recording has its own owner, and US law gives that owner a separate right over digital audio transmissions.
  • Outside the US: each country has its own collecting societies and rules. Ask the one where the venue is.

Treat this as general guidance rather than legal advice. For a ticketed or recurring show with covers, call the licensing body first.

Going live on your own channel

A live video channel takes your stream over RTMP from OBS Studio, vMix, Wirecast, Larix or a hardware encoder and plays it as HTTPS/HLS in any browser, so fans need no app. The player shows only your channel, with no adverts.

  1. Open a Free video channel. It serves up to 10 viewers at a time and is made for testing your encoder and player.
  2. Enter your channel's RTMP connection details in OBS under Settings, Stream.
  3. Press Start Streaming during soundcheck and open your channel's player: it should show your stage.
  4. Watch the test on a phone using its mobile connection, not the venue Wi-Fi, and listen on headphones.
  5. For the show itself, move to Pro: one channel at 1080p for up to 1,000 people watching together, with traffic not counted. It starts with 14 days free, then is billed unless you cancel.
  6. Share the HLS link, or paste the one-line embed code into the band's or venue's website.
  7. Press Start Recording in OBS as well as Start Streaming, so you keep a copy of the night.

That recording matters: live broadcasts are not saved into the channel's video library. Upload the file afterwards and the replay sits in your library, ready for the 24/7 TV station on Pro and Platinum to play between shows. If the band has no site yet, web hosting gives you one for the player and the tour dates.

When this setup is not enough

Think about the size of the night first. A channel takes up to 5 Mbps, so it is not the place for a 4K stream. Pro and Platinum reach up to 1,000 viewers at the same moment; a festival headliner expecting more needs a bigger setup. Platinum runs two channels, which helps when a venue has two stages or wants a backup feed, and it serves each viewer from the closest of five CDN cities. Channels run in New York or Bucharest, on availability.

No plan fixes a weak venue connection either. If the upload test fails, the answer is a better line or a lower bitrate, not a different host.

Put your next gig on screen

Open a free channel, run your soundcheck test for up to 10 viewers, and move to Pro when the doors open.

Your questions

Can I stream a gig with just a phone?

You can, with an RTMP app such as Larix, which the channel accepts. The weak point is sound: a phone microphone hears the room, not the mix, so the band sounds distant and the bass booms. If you can, feed the desk into the phone through an audio adapter, or use a laptop with OBS and an audio interface.

Why does my stream sound worse than it did in the room?

Almost always because the stream is getting the front-of-house mix, which is balanced for loud amps and drums already in the room. Ask the engineer for a separate stream mix on an aux send, add a little audience sound, and check the levels so the loud songs stay out of the red on the OBS meter.

Should I stream at 1080p or 720p?

It depends on the venue's upload speed. With the channel's 5 Mbps limit, 720p sits comfortably above YouTube's 3 Mbps minimum for that resolution, while 1080p at 30 frames per second, once the audio is counted, falls just under YouTube's 5 Mbps minimum. If you have measured a fast, steady line, 1080p works; if not, 720p will look smoother.

Can fans watch the concert again afterwards?

Not automatically, because live broadcasts are not recorded into the channel's library. Record in OBS while you stream, then upload the file from your dashboard. On Pro and Platinum the TV station can play it around the clock between your live shows.